Open account

Home / Strategies / Scaled entries, single stop

Scaled entries, single stop

Instead of betting everything on one price, you split the position into two to four limit orders spread across a zone of interest, all protected by the same stop. Total risk is fixed before the first order, so each extra fill never increases the planned maximum loss. It reduces reliance on nailing the exact price and improves your average when the pullback runs deeper.

Updated Nov 22, 2026 · Equipe FuturosDesk

Category

Risk management

Level

Intermediate

Timeframe

1h · 4h · 1d

Risk : Reward

1 : 2.5

Scale-in zone1st orderAverage entry3rd orderTargetEntryStop
Illustrative chart, not real market data.

When it works

  • When the entry area is a zone (support, value area, order block) rather than a single price.
  • On pullbacks within a trend defined on the higher timeframe.
  • When there is enough liquidity for limit orders to fill without meaningful slippage.

When to avoid it

  • As a way to average down after the thesis is already invalidated: that is not scaling in, it is denial.
  • When the stop would have to sit so far away that risk per order becomes trivial.
  • On fast breakouts, where price rarely comes back to fill the lower orders.

Setup

  1. Define the entry zone and the invalidation level before placing any order. The stop sits outside the zone.
  2. Fix total risk for the idea (for example 1% of equity) and compute each order's loss to the stop.
  3. Distribute size across orders: equal, or heavier on orders closer to the stop (where risk per contract is smaller).
  4. Add up the potential loss of every order if all fill: the total must equal your fixed risk.

Entry trigger

  • Place limit orders at the top, middle and bottom of the zone.
  • If only the first order fills and price moves your way, accept the smaller position: do not chase the rest.
  • Cancel unfilled orders if structure changes before they are hit.

Stop

One stop for the whole position, below the zone and the level that invalidates the idea. It does not move as orders fill; only the average price changes. Lowering the stop to fit another order breaks the entire logic of the method.

Exits and targets

  • Compute targets from the actual average price, not from the first order's price.
  • Take partials at a 2R target measured from the average and move the stop to the average entry.
  • Cancel any unfilled orders once the first target is reached.

Risk management

Hypothetical example

Hypothetical example: BTC pulls back into a support zone between 58,000 and 60,000, with a single stop at 57,000. With total risk of 1,000 dollars, you place three orders at 60,000, 59,000 and 58,000. If all fill, the average is 59,000 and the combined loss to 57,000 is exactly 1,000. A 2.5R target from the average sits near 64,000.

Common mistakes

  • Sizing risk per order and forgetting that, with every order filled, total loss is their sum.
  • Adding unplanned orders below the zone as price keeps falling.
  • Setting targets from the first order's price and ending up with a worse reward-to-risk than expected.

Practise with small size

Test it with low fees on MEXC

Related strategies

FAQ

Is scaling in the same as averaging down?

No. When scaling in, every order and the stop are defined in advance with fixed total risk. Averaging down without a plan, after being wrong, increases risk without limit.

How many orders should I use to scale in?

Two to four is usually enough. More than that adds fees and complexity without meaningfully improving the average price.

How do I size each order?

Divide total risk by the number of orders, then divide each slice by the distance between that order's price and the stop. The result is the contract quantity for that order.